Metrohm tiamo 2.4 (process analysis) - Manual (Page 1437)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1421
6.7 Sensors subwindow
6.7.1 Sensors - General
Subwindow: Configuration ▶ Sensors
Sensors subwindow
The Sensors subwindow contains the sensor table with all automatically
recognized and manually added sensors. It can be shown in the Configu-
ration program part as a part of the configuration view or (if not present
on the user interface) in a separate window with View
▶ Quick access.
The subwindow can be enlarged and reduced as required; it can also be
maximized.
Intelligent sensors (IS)
Intelligent sensors have a data chip with stored sensor data. When con-
nected to intelligent devices (e.g. 857 Titrando) via 854 iConnect, they
are recognized automatically and stored in the sensor table.
Nonintelligent sensors
Nonintelligent sensors must be added manually to the sensor table.
Standard sensors
By default, the sensor table contains the following sensors; these cannot
be deleted:
￭ Conductivity sensor (conductivity sensor)
￭ ISE electrode (ion-selective electrode)
￭ Metal electrode (metal electrode)
￭ pH electrode (pH electrode)
￭ Temperature sensor (temperature sensor)
6.7.2 Sensor table
6.7.2.1 Sensor table
Subwindow: Configuration ▶ Sensors
Contents
In the sensor table the following information about the configured sensors
is shown as standard:
Sensor name
Name of the sensor.
Sensor type
Type of the sensor. Intelligent sensors will be marked with IS and shown
automatically in green.