Metrohm tiamo 2.4 (process analysis) - Manual (Page 1313)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1297
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
NOTE
If the option not defined is selected, then no ports can be selected in
the Digital outputs tab, because it is not known to which device this
block refers.
If a method is generated independently of a device, then a device for
the editing of the block will nevertheless still need to be selected. One
can however afterwards set the device name back to not defined.
Device type
Display of the device type. If a device is selected under Device name,
then this Device type field can no longer be edited, and the device type
belonging to the selected device is displayed instead.
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection IO Controller | Stepping Motor Controller
Default value IO Controller
5.6.11.2.3 DIGITAL OUT - Digital outputs
Tab: Method ▶ DIGITAL OUT ▶ Digital outputs
Command name
Name of the command.
Entry 25 characters
Table
The actuation of a digital output is parameterized in every line of the Digi-
tal outputs table.
The function Timer is used with the parameters Start delay and Work-
ing time to enable time-staggered parameterization
One port can not be used more than once within a block.