Metrohm tiamo 2.4 (process analysis) - Manual (Page 1380)

6.3 Configuration data
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1364 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Examples for 765 Dosimat
Parameters Binary pattern Function
Start Dos1 *******p****** Starts Dosimat 1 (Titrino via "acti-
vate")
Start Dos2 *****p******** Starts Dosimat 2 (Titrino via "acti-
vate")
Start Dos* *****p*p****** Starts Dosimat 1 and 2 (Titrino via
"activate")
6.3.3.4 Templates - Conductivity standards
6.3.3.4.1 Manage conductivity standards
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Conductivity stand-
ards ▶ Conductivity standards
Conductivity standards can be defined in the dialog window, which
can be selected with the command CAL Cond. The table cannot be
edited.
[New]
Creation of a new conductivity standard. The window Edit conductivity
standard opens, in which a new conductivity standard can be defined
(see Chapter 6.3.3.4.2, page 1364).
[Properties]
Edits the selected conductivity standard. The window Edit conductivity
standard opens, in which the conductivity standard can be edited (see
Chapter 6.3.3.4.2, page 1364).
[Delete]
Deletes the selected conductivity standard.
[Copy]
Copies the selected conductivity standard, which is saved under the name
Copy of.....
6.3.3.4.2 Edit conductivity standard
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Conductivity stand-
ards ▶ Conductivity standards ▶ Edit conductivity standard
With [New] or [Properties] in the dialog window Conductivity stand-
ards, the dialog window Edit conductivity standard opens for entering
a new conductivity standard or for editing an existing conductivity stand-
ard.