Metrohm tiamo 2.4 (process analysis) - Manual (Page 1599)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1583
Entry 1000 characters
Default value empty
7.14.3 Properties - Settings
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Settings
Device assignment
Instrument for reference channel
Name of the reference instrument assigned to the instrument for the mea-
suring channel in a two-channel instrument setup. It measures the refer-
ence, while the instrument for the measuring channel measures the sam-
ple solution at the same time.
Selection 'Instrument name' | not defined
'Instrument name'
All spectrometers for which Instrument for reference channel =
not defined is selected.
not defined
In a one-channel instrument setup and for spectrometers that have
already been assigned in a two-channel instrument setup, not
defined has to be selected.
Instrument for measuring channel
Only visible for two-channel instrument setups. Name of the instrument
for sample solution measurement.
Light source
Type
Type of light source used.
Selection continuous | pulsed
Default value continuous
Analog output
on | off (Default value: on)
If this option is enabled, then the measuring signal is output at the analog
output of the spectrometer. If the connected spectrometer is not
equipped with an analog output, then this option will be ignored.
Sensitivity
Setting of the sensitivity of the analog output. The number of mAU
(absorption units) represented by 1 mV is indicated.