Metrohm tiamo 2.4 (process analysis) - Manual (Page 1685)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 Manual control
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1669
8.3 Manual control - Device selection
Program part: Manual control
In the subwindow for the device selection, you can select the devices or
function units of devices for which you would like to trigger functions
manually. For this purpose, they are displayed in tree-form. All devices
configured in the device table with the status "ok" are displayed with the
device name and (in brackets) the device type number. The currently
selected device is shown with a blue background. Devices that are still
performing manually triggered actions are shown in red letters.
8.4 Manual control - Functions
In the subwindow for functions/parameters, the functions for the manual
control of the selected device and the corresponding parameters can be
selected. In addition, the measured values for ongoing actions and mes-
sages are displayed here.
Depending on the device different functions are possible.
8.4.1 Dosing
8.4.1.1 Dosing - Overview
Program part: Manual control
If in the subwindow for the device selection, the group Dosing device or
a single Dosing device is selected, then the functions and parameters
belonging to these dosing devices are displayed in the subwindow Func-
tions/Parameters.
Dosing functions
The dosing functions for exchange and dosing units are displayed on the
following tabs:
￭ General
￭ Preparing
￭ Filling
￭ Emptying
￭ Fixed volume
￭ Dosing
Instruments
The dosing functions can be carried out with dosing devices that are built
in or connected to the following devices:
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 784, 785, 794,
795, 798, 799