Metrohm tiamo 2.4 (process analysis) - Manual (Page 271)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 255
Autoscaling
on | off (Default value: on)
If this check box is activated, then the. In this case the fields Start value
and End value cannot be edited.
Tabs
Further properties of a template for the overlaying of curves can be set on
the following 4 tabs:
￭ x axis
Parameters for the graphical display of the overlaid curves on the x
axis.
￭ y axis
Parameters for the graphical display of the overlaid curves on the y
axis.
￭ Options
Options for the graphical display of the overlaid curves.
￭ Comment
Enter comment on the template.
4.4.3.2.2 Curve overlay - x axis
Dialog window: Database ▶ Tools ▶ Templates ▶ Curve overlay tem-
plates... ▶ Curve overlay templates ▶ [Properties] ▶ Properties - Curve overlay -
'Name'
Parameters for the graphical display of the overlaid curves on the x axis.
x axis
Size
Selection of the quantity to be shown on the x axis.
Selection Command-dependent selection
Label
Freely definable axis label for the x axis. With auto the designation from
the field Size will be used.
Entry 25 characters
Default value auto
Scaling
Start value
Initial value for scaling the x axis.
Input range -1.0 E12 - 1.0 E12
Default value 0.0