Metrohm tiamo 2.4 (process analysis) - Manual (Page 1744)

9.3 Determinations
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1728 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
9.3 Determinations
9.3.1 Starting single determination
How to proceed?
Single determination without statistics
1 Select program part Workplace.
2 In the Run subwindow, select the Single determination tab.
3 If desired, enter Determination parameters.
4 In the Method list box select the method to be used for carrying out
the determination.
The subwindow Method shows the method loaded.
5 If a method was loaded in which the check box Statistics in the
START command is enabled, disable the check box Statistics on
the tab Single determination.
6 Enter sample data.
7 Click on [Start].
The single determination will be started. The subwindow Method
shows active tracks and commands, the subwindow Live display
live curves, measured values and messages.
Single determination with statistics
1 Select program part Workplace.
2 In the Run subwindow, select the Single determination tab.
3 If desired, enter Determination parameters.
4 In the Method list box select the method to be used for carrying out
the determination.
The subwindow Method shows the method loaded.