Metrohm tiamo 2.4 (process analysis) - Manual (Page 1133)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1117
Request for standard exchange
on | off (Default value: on)
If this option is enabled, a request for manual solution exchange is dis-
played after each measurement. This parameter must be disabled for
automatic solution exchange when calibrating with a sample changer.
5.6.5.7 CAL MEAS Conc
5.6.5.7.1 CAL MEAS Conc - Overview
Dialog window: Method ▶ CAL MEAS Conc ▶ Properties.. ▶ CAL MEAS Conc -
'Command name'
Measuring command for calibration with ISE electrodes, which is
used together with the command CAL LOOP Conc.
Devices
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836, 857, 904, 905, 906, 907
pH/Ion - Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command CAL MEAS Conc are configured on
the following 2 tabs:
￭ General/Hardware
Parameters for devices, sensors and stirrers.
￭ Measuring parameters
Parameters for setting the measurement procedure.
Command variables
The following command variables are generated in the method run by the
command CAL MEAS Conc and can be used in formulas under the des-
ignation 'Command name.Variable designation':