Metrohm tiamo 2.4 (process analysis) - Manual (Page 264)

4.4 Templates
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
248 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Selection not defined | 50 characters
Default value not defined
Autoscaling
on | off (Default value: on)
If this check box is activated, all axes in the curve window are scaled auto-
matically. In this case the fields Start value and End value cannot be
edited.
Tabs
Additional properties for the curve field can be set on the following 4
tabs:
￭ x axis
Parameters for the graphical display of the curve on the x axis.
￭ y1 axis
Parameters for the graphical display of the curve on the y1 axis (left-
hand y axis).
￭ y2 axis
Parameters for the graphical display of the curve on the y2 axis (right-
hand y axis).
￭ Options
Options for graphical display of curves.
4.4.1.4.3.13 Report template - Calibration curve field
Program window: Database ▶ Report template
Calibration curve fields are used for showing calibration or standard addi-
tion curves in the report.
Insert
In order to insert calibration curve field into a report template the corre-
sponding symbol must be selected on the Module bar and placed on the
report template by creating a field with the left-hand mouse key.
Properties
X pos.
x-position within the permitted section.
Input range 0.0000 - (max. page width) mm
Y pos.
y-position within the permitted section.
Input range 0.0000 - (max. page height) mm