Metrohm tiamo 2.4 (process analysis) - Manual (Page 1248)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1232 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Appearance
The command has the following appearance:
Parameters
The parameters for the command RACK are configured in the following
dialog window:
￭ RACK - Properties
Command variables
The following command variables are generated in the method run by the
command RACK and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
5.6.7.7.2 RACK - Properties
Dialog window: Method ▶ RACK ▶ Properties... ▶ RACK - 'Command name'
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined