Metrohm tiamo 2.4 (process analysis) - Manual (Page 628)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
612 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Evaluation with volume window (mL)
[New]
Open the dialog window Volume window # in which the parameters
for a new window can be entered (see Chapter 5.6.3.3.3.10, page
618).
[Properties]
Open the dialog window Volume window # in which the parameters
for the selected window can be edited (see Chapter 5.6.3.3.3.10, page
618).
[Delete]
Delete the window selected in the table.
5.6.3.3.3.7 MET U - Additional evaluations
Tab: Method ▶ MET U ▶ Properties... ▶ Additional evaluations
Figure and parameters: see DET U - Additional evaluations
Command name
Name of the command.
Entry 25 characters
The following additional methods for evaluation of titration curves can be
activated and defined on this tab:
Fixed endpoint evaluation
Fixed endpoint evaluation
on | off (Default value: off)
If this check box is activated, then the associated values for the other
measured quantities will be interpolated with a fixed measured quantity
(Measured value, Time or Volume) for the fixed endpoint from the
measuring point list.
on | off (Default value: off)
If this check box is activated, then the associated values for the other
measured quantities will be interpolated with a fixed measured quantity
(Measured value, Volume or Time) for the fixed endpoint from the
measuring point list.
Moves the selected line up (changes the sequence).
Moves the selected line down (changes the sequence).