Metrohm tiamo 2.4 (process analysis) - Manual (Page 996)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
980 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Designation Description
.FP{x}.TEM Temperature for the fixed endpoint × (1…9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1…9) is reached
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
on the measuring point list
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the mea-
suring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.MA.MEA Maximum measured value (U
ind
) in mV
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MI.MEA Minimum measured value (U
ind
) in mV
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
5.6.4.6.2 MEAS Upol - General/Hardware
Tab: Method ▶ MEAS Upol ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters