14 meas opt, 1 meas opt - overview, Meas opt – Metrohm tiamo 2.4 (process analysis) User Manual
Page 1061
■■■■■■■■■■■■■■■■■■■■■■
5 Method
tiamo 2.4 (for Process Analysis)
■■■■■■■■
1045
End wavelength
Upper limit of the evaluation range.
Input range
100.0 - 2,000.0 nm
Default value
1,000.0 nm
5.6.4.14
MEAS Opt
5.6.4.14.1
MEAS Opt - Overview
Dialog window: Method
▶ MEAS Opt ▶ Properties... ▶ MEAS Opt - 'Command
name'
Command for the measurement of the sample solution at a defined
wavelength.
Devices
This command can be executed with the following instruments:
Spectrometer: Avantes
NOTE
In a one-channel instrument setup, only instruments for which the entry
not defined is selected under Instrument for reference channel in
the configuration can be selected.
In a two-channel instrument setup, only instruments which are assigned
an instrument for the reference channel can be selected (see Chapter
7.14.3, page 1583).
Photometer: 089
Appearance
The command has the following appearance:
Parameters
The parameters for the MEAS Opt command are set on the following
three tabs:
■
General/Hardware
Parameters for instrument.
■
Measuring parameters
Parameters for setting the measurement procedure.