Metrohm tiamo 2.4 (process analysis) - Manual (Page 702)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
686 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Stop measured value
Stop when the entered measured value for a measuring point has been
exceeded or not reached since the start of the titration.
Input range 0.00000 - 2,000.00
Selection off
Default value off
Stop time
Stop when the entered time has elapsed after the start of the titration
(including start conditions).
Input range 0 - 999,999 s
Selection off
Default value off
Filling rate
Rate (volume/time unit) at which the buret is to be filled after the titration.
The maximum filling rate depends on the cylinder volume of the exchange
unit or dosing unit used.
Input range 0.01 - 166.00 mL/min
Selection maximum
Default value maximum
5.6.3.3.6.6 MET Cond - Conductometric evaluation
Tab: Method ▶ MET Cond ▶ Properties... ▶ Conductometric evaluation
Command name
Name of the command.
Entry 25 characters
Parameters for the conductometric evaluation of the titration curve with
automatic equivalence point recognition are defined on this tab. One of
the following evaluation methods can be chosen:
Conductometric evaluation
Selection Evaluation without window | Evaluation with
volume window (mL)
Default value Evaluation without window
Evaluation without window
The measurement curve is smoothed with the value specified for the
Smoothing parameter with this option. Only the endpoint with the
highest value will be evaluated. If you wish to evaluate several end-
points, then you must work with Evaluation with volume window
(mL).