Metrohm tiamo 2.4 (process analysis) - Manual (Page 1577)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1561
Action
The actions can only be edited if monitoring is switched on.
If during monitoring it is found that the validity period has expired then
one of the following actions will be triggered automatically at start test:
Selection Record message | Display message | Cancel
determination
Default value Display message
Record message
The message that the validity period has expired will be automatically
saved with the determination.
Display message
A message is displayed and you can select whether you want to con-
tinue the sequence or cancel it. If the sequence is continued then the
message that the validity period has expired will be automatically saved
with the determination.
Cancel determination
The running determination will be automatically canceled. The follow-
ing message must be confirmed with [OK].
7.10 756/831 Coulometer
7.10.1 756/831 Coulometer - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties… ▶ Properties - 'De-
vice type' - 'Device name'
The parameters for the 756 and 831 Coulometers are set on the follow-
ing tabs:
￭ General
General device information such as device name, device type, serial
number, etc.
￭ RS-232
Selection of the serial interface the Coulometer is connected to.
￭ GLP
Information on GLP tests and GLP monitoring.
7.10.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
On the tab General, general properties of the device are displayed.
Device name
Designation of the device (can be freely defined by user).