Metrohm tiamo 2.4 (process analysis) - Manual (Page 1697)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 Manual control
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1681
Swing rate
Swing rate for manual control of the Swing Head on the sample changer.
Input range 10 - 55 °/s
Default value 20 °/s
[Initialize rack]
The attached rack is initialized.
NOTE
When the rack is initialized, the following actions are carried out:
￭ Rack rotates to the position for reading out the rack code.
￭ Rack data on the rack code is transferred to the sample changer.
￭ Lifts are moved upwards to 0 mm.
￭ The robotic arm is moved back.
8.4.4.3 Sample changer - Moving
Program part: Manual
Moving to the desired rack position, lift position or robotic arm position
can be triggered manually here.
Rack position
Setting the rack position.
Current position
Shows the current rack position.
Target position
Selection or entry of the rack position to be approached.
Input range 1 - n (depending on rack)
Default value 1
Selection Special beaker 1 - 16
Shift rate
Shift rate for manual control of the sample changer.
Input range 5 - 20 °/s
Default value 20 °/s
[Start]
Starts moving to the target position. After the start, the button changes to
[Stop], the two lower buttons are shown as disabled (gray) and Move...
is shown as status message instead of Ready.