Metrohm tiamo 2.4 (process analysis) - Manual (Page 1395)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1379
6.4.1.5 Audit Trail - Filter selection
Program window: Configuration ▶ Tools ▶ Audit Trail... ▶ Audit Trail
Filter
Selection of the filter with which the Audit Trail table is to be filtered:
Selection All entries | Quick filter | Temporary filter | Fil-
ter name
Default value All entries
All entries
The table is shown unfiltered.
Quick filter
The table is filtered according to the last defined quick filter (see Chap-
ter 6.4.2.3.3, page 1383).
Temporary filter
The table is filtered according to the last defined, not saved special fil-
ter (see Chapter 6.4.2.3.4.1, page 1384).
Filter name
The table is filtered according to the selected and saved special filter
(see Chapter 6.4.2.3.4.1, page 1384).
6.4.1.6 Audit Trail - Navigation bar
Program window: Configuration ▶ Tools ▶ Audit Trail... ▶ Audit Trail
The navigation bar shown beneath the Audit Trail table is used for navi-
gating through extensive tables in which not all the entries can be shown
at the same time. It contains the following elements:
Jumps to first set of entries in the Audit Trail table.
Returns to previous set of entries in the Audit Trail table.
Display of the selected set #### - #### of entries in the Audit Trail table.
If the table has not been filtered then the total number of entries will also
appear. If the table has been filtered then the total number of filtered
entries will appear with the info (filtered).
Moves to next set of entries in the Audit Trail table.