Metrohm tiamo 2.4 (process analysis) - Manual (Page 550)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
534 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Window = Time
Input range
0 - 999999 s
Default value 999999 s
Gran evaluation
NOTE
This evaluation method is possible only with Titrando and 855.
Gran evaluation
on | off (Default value: off)
If this option is enabled, then titration curves will be evaluated in accor-
dance with the Gran Plot procedure(see Chapter 5.6.3.10.4, page 932).
Initial volume
Volume which must be present in the measuring vessel before the com-
mand is started.
Input range 0.01 - 9999.99 mL
Default value 50.00 mL
Lower limit
Value for the lower limit of the Gran evaluation range.
Input range -2000.0 - 2000.0 mV
Default value -2000.0 mV
Upper limit
Value for the upper limit of the Gran evaluation range.
Input range -2000.0 - 2000.0 mV
Default value 2000.0 mV
5.6.3.2.4.8 DET Ipol - Additional measured values
Tab: Method ▶ DET Ipol ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Entry 25 characters
A maximum of 6 additional measured values can be defined on this tab.
These values can then be saved together in additional measured value col-
umns with the measured values present in the default settings.