Metrohm tiamo 2.4 (process analysis) - Manual (Page 1250)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1234 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Parameters
The parameters for the command HEATER are configured in the follow-
ing dialog window:
￭ HEATER - Properties
Command variables
The following command variables are generated in the method run by the
command HEATER and can be used in formulas under the designation
'Command name.Variable designation':
Designa-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command has
never ended
5.6.7.8.2 HEATER - Properties
Dialog window: Method ▶ HEATER ▶ Properties... ▶ HEATER - 'Command name'
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display of the device type. If a device is selected under Device name,
then this Device type field can no longer be edited, and the device type
belonging to the selected device is displayed instead.