Metrohm tiamo 2.4 (process analysis) - Manual (Page 863)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 847
Designation Description
.LP.IGE Current pulsed current for the last measuring point in
the measuring point list in mA
.LP.MEA Measured value for the last measuring point in the
measuring point list in mV
.LP.QTY Measured value (water) for the last measuring point in
the measuring point list in µg
.LP.TEM Temperature for the last measuring point of the mea-
suring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.UGE Voltage at the generator electrode for last measuring
point of the measuring point list in V
.MTE Temperature measurement with sensor; 1 = on, 0 =
off
.NMP Number of measuring points in measuring point list
.SME Start measured value (measured value after processing
the start conditions) in mV
.STE Start temperature (temperature after processing of the
start conditions) in °C
5.6.3.7.2 BRC - General/Hardware
Tab: Method ▶ BRC ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the device, the electrodes and the stirrer are
defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined