Metrohm tiamo 2.4 (process analysis) - Manual (Page 397)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 381
¯Dos.r.
Upper limit value for dosing rate monitoring infringed.
_Temp.
Lower limit value for temperature monitoring infringed.
¯Temp.
Upper limit value for temperature monitoring infringed.
*
The dosing has been paused.
4.8.2 Curves - Measuring point list
Subwindow: Database ▶ Curves
With the context-sensitive menu item Measuring point list… in the
curve window the dialog window Measuring point list - 'Command
name.#' opens for showing the measuring point list for the selected
curve.
The display of the measuring points in the table can be defined per win-
dow and per command type in the Properties - Curve #.
4.8.3 Curves - Monitoring report
Subwindow: Database ▶ Curves
If the method contains commands of the type STAT or DOS, then with
the context-sensitive menu item Monitoring report… in the curve win-
dow the dialog window Monitoring report - 'Command name' can
be opened. In this window information on limit violations occurred are
displayed for each monitoring switched on.
The following columns are displayed:
Time [s]
Time in s until limit violation.
Limit
Selection lower | upper | ok
lower
Lower limit value exceeded.
upper
Upper limit value exceeded.
ok
Measured value within the limits again.
[pH]/[U]
Limit for the measured value.