Metrohm tiamo 2.4 (process analysis) - Manual (Page 1414)

6.6 Subwindow Titrants/Solutions
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1398 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
6.6 Subwindow Titrants/Solutions
6.6.1 Titrants/Solutions - General
Subwindow: Configuration ▶ Titrants/Solutions
Subwindow Titrants/Solutions
The Titrants/Solutions subwindow contains the solution table with all
automatically recognized and manually added titrants and auxiliary solu-
tions. It can be shown in the Configuration program part as a part of
the configuration view or (if not present on the user interface) in a sepa-
rate window with View
▶ Quick access. The subwindow can be
enlarged and reduced as required; it can also be maximized.
Titrants
Titrants are used as solutions for the titration commands DET, MET, SET,
KFT and STAT. They can be used in exchange units or dosing units.
Auxiliary solutions
Auxiliary solutions are used as solutions for the dosing commands ADD,
DOS and LQH. They can be used in exchange units or dosing units.
Intelligent exchange units (IEU) and dosing units (IDU)
Intelligent exchange units and dosing units have a data chip with stored
solution data. When mounted on intelligent devices (e.g. Titrando) they
are recognized automatically and stored in the solution table.
Non-intelligent exchange units (EU) and dosing units (DU)
Non-intelligent exchange units and dosing units must be added manually
to the solution table.
6.6.2 Solution table
6.6.2.1 Solution table
Subwindow: Configuration ▶ Titrants/Solutions
Contents
In the solution table the following information about automatically recog-
nized or manually added solutions is shown as standard:
Solution name
Name of the solution.
Concentration
Concentration (value and unit) of the solution.