Metrohm tiamo 2.4 (process analysis) - Manual (Page 1650)

7.20 IO controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1634 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
2-point controller Creating a new controller of the 2-point controller type.
PID controller Creating a new controller of the PID controller type.
PWM controller Creating a new controller of the PWM controller type.
[Edit]
Opens the dialog Properties - 'Controller type' in order to edit the
selected controller (see Chapter 7.20.8.1, page 1634).
[Delete]
Deletes the selected controller.
7.20.8.1 Properties - Controller type
Controller name
Freely selectable designation for the controller. This designation is used in
the program to actuate the controller.
Entry 1 - 50 characters
Default value Controller 1
The following characters must not be part of the
controller designation: \, ', ., {, }, [, ].
Controller behavior with
Action at power on
Action which is to be executed when the device is switched on.
Selection Stop control | Continue
Default value Stop control
Action with emergency stop
Action which is to be performed with an emergency stop.
Selection Stop control | Ignore emergency stop | Con-
tinue control
Default value Stop control
Action with end of control
Action which is to be performed with the end of the control or when
there is an error.
Selection Retain values for outputs | Set default values
for outputs
Default value Retain values for outputs