Metrohm tiamo 2.4 (process analysis) - Manual (Page 792)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
776 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
temperature will be measured continuously. This value is used for temper-
ature correction in pH measurements.
Titrando, 855
Input range
-20.0 - 150.0 °C
Default value 25.0 °C
Titrino
Input range
-170.0 - 500.0 °C
Default value 25.0 °C
Time interval measuring point
Time interval for entering a measuring point in the measuring point list.
Titrando, 855
Input range
0.1 - 999999 s
Default value 2.0 s
Titrino
Input range
0.08 - 16200 s
Default value 2.00 s
5.6.3.4.6.6 SET Upol - Stop conditions
Tab: Method ▶ SET Upol ▶ Properties... ▶ Stop conditions
Command name
Name of the command.
Entry 25 characters
Conditions for stopping the titration. If several stop conditions are set,
then the criterion which is fulfilled first will stop the titration.
Stop volume
Stops when the given volume has been added after the start of the titra-
tion (including start conditions). The stop volume should be adapted to
suit the sample weight or the titration vessel size.
Titrando, 855
Input range
0.00000 - 9999.99 mL
Default value 100,000 mL
Selection off
Titrino
Input range
0.000 - 9999.99 mL
Default value 100.00 mL
Selection off