Metrohm tiamo 2.4 (process analysis) - Manual (Page 1680)

7.21 Stepping Motor Controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1664 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
7.21.6.1 Properties Stepping motor
Dialog window Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'De-
vice type' - 'Device name' ▶ Stepping motors ▶ [Edit] ▶ Properties Stepping
motor
In the dialog window Properties Stepping motor the properties for the
individual stepping motors are set.
Port
Display of the internal designation for a stepping motor of the type Dig-
Out_x_y_z, whereas x stands for the controller; y for the digital output
terminal and z for the output on this terminal.
Port description
Freely selectable designation for a stepping motor port. This designation is
used in the program to actuate the port.
Entry 50 characters
Default value DigOut_x_y_z
The following characters must not be part of the
port description: \ , ', ., {, }, [, ].
Type
Selection of the port type.
Selection Linear drive | Rotary drive
Default value Linear drive
Default values for commands
Action
Action that the stepping motor is to carry out.
Selection 'empty' | Reference position | Relative posi-
tion | Absolute position | End position | Reset
Default value 'empty'
Reference position
Move to the reference position of the stepping motor.
Relative position
Move to a relative position, whereby the stepping motor moves rela-
tive to the current position by the value defined under Distance/
Angle.
Absolute position
Move to an absolute position, whereby the stepping motor moves to
the value defined under Distance/Angle.
End position
Move to the end position of the stepping motor.