Metrohm tiamo 2.4 (process analysis) - Manual (Page 490)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
474 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Volume after EP
When the number of equivalence points defined under Stop EP has been
found, this volume will be added. In this way you can see the curve shape
after the equivalence point is reached.
Titrando, 855
Input range
0.01000 - 9999.99 mL
Selection off
Default value off
Stop time
Stops when the preset time (including start conditions) has elapsed since
the start of the titration.
Titrando, 855
Input range
0 - 999999 s
Selection off
Default value off
Filling rate
Speed with which the dosing cylinder is to be refilled after the titration.
The maximum filling rate depends on the cylinder volume of the exchange
unit or dosing device used.
Titrando, 855
Input range
0.01 - 166.00 mL/min
Selection maximum
Default value maximum
Titrino
Input range
0.01 - 150.00 mL/min
Selection maximum
Default value maximum
5.6.3.2.2.6 DET pH - Potentiometric evaluation
Tab: Method ▶ DET pH ▶ Properties... ▶ Potentiometric evaluation
Command name
Name of the command.
Entry 25 characters
Parameters for the potentiometric evaluation of the titration curve with
automatic equivalence point recognition. One of the following evaluation
methods can be chosen: