Metrohm tiamo 2.4 (process analysis) - Manual (Page 429)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 413
Command without comment Command with comment
5.2.5 Checking a method
Menu item: Method ▶ File ▶ Method check
With the icon or the File ▶ Method check menu item a method
check for the method in focus is triggered. The following points are
checked:
￭ Are the tracks defined in CALL commands available?
￭ Are the targets of loop commands defined?
￭ Are the variables used in formulas available?
￭ Does a track contain more than one command with conditioning acti-
vated?
￭ Does a special track (series start track, series end track, exit track and
error track) contain a command with conditioning activated?
A respective error message is displayed for each error found. The check
has to be started again afterwards. When the method check has been
completed successfully, it is confirmed with a message.
5.2.6 Saving a method
Menu item: Method ▶ File ▶ Save / Save As…
The icon or the File ▶ Save menu item is used to save an existing
focused method again under its own name without opening the Save
method window.
When saving a newly created method with the File ▶ Save menu item
or when saving an existing method with the File ▶ Save As… menu
item, the Save method window is opened, in which the method group
can be selected and a method name can be entered or selected.
Method group
Method group
Selection of the method group where the method is to be stored (see
Chapter 5.4.1, page 428).
Selection Method groups | Main group
Default value Main group
Method table
The method table contains information about all methods of the selected
method group. The table cannot be edited. The table can be sorted