Metrohm tiamo 2.4 (process analysis) - Manual (Page 1483)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1467
6.9.3.4 History - Limits
Dialog window: Configuration ▶ Common variables ▶ [Edit] ▶ Properties ▶ Com-
mon variable - 'Name' ▶ History ▶ [Limit value] ▶ Limits for Common variable -
'Name'
In the dialog window Limits for common variable both warning and
intervention limits can be defined for the values of the common variables.
If you have defined limits then these will be shown in the graph in
orange for warning limits and red for intervention limits. However,
whether these limits are observed is not monitored, i.e. exceeding these
limits does not trigger any action.
Warning limits for common variable
on | off (Default value: off)
If this option is enabled then the values of the common variables will be
shown in orange if these limits are exceeded.
Lower limit
Lower warning limit for common variable.
Input range -1.0E+99 - 1.0E+99 (max. 10 digits)
Upper limit
Upper warning limit for common variable.
Input range -1.0E+99 - 1.0E+99 (max. 10 digits)
Intervention limits for common variable
on | off (Default value: off)
If this option is enabled then the values of the common variables will be
shown in red if these limits are exceeded.
Lower limit
Lower warning limit for common variable.
Input range -1.0E+99 - 1.0E+99 (max. 10 digits)
Upper limit
Upper warning limit for common variable.
Input range -1.0E+99 - 1.0E+99 (max. 10 digits)