Metrohm tiamo 2.4 (process analysis) - Manual (Page 195)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Workplace
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 179
NOTE
No live parameters can be edited with methods which have been
signed at Level 2 and thus locked.
Errors whose content is defined by a formula cannot be modified live.
If an active SEQUENCE command is canceled, then only the individual
command in the sequence that is currently active will be canceled, and
the next individual command will be started.
3.7.4 Method window - Cancel command
Subwindow: Workplace ▶ Method
If a workplace is in BUSY status, then the context-sensitive menu item
Cancel can be used to stop the running of an active command immedi-
ately and to jump directly to the next command. This applies only to com-
mands with live display. This cancellation is documented in the determina-
tion (under Messages) and in the Audit Trail. The data and variables
which have already been generated by the command that was canceled
will be saved.
3.8 Subwindow Live display
3.8.1 Live display - General
Subwindow: Workplace ▶ Live display
Subwindow Live display
In both of the subwindows Live display 1 and Live display 2, live
curves, measured values and messages on the method started in the run
window on the tab Single determination or Determination series are
displayed. The subwindows can be activated in the program part Work-
place during the definition of the layout and thus made visible. They can
be enlarged and reduced as required; they can also be maximized.
The display of curves and measured values in the live window can be
defined per window and per command type in the Properties.
Tabs
The subwindows Live display 1 and Live display 2 are comprised of
the following tabs:
￭ Tracks
A tab is displayed for each track which is lettered with the name of the
track.
￭ Application note
Displaying the application message defined in the command START.