Metrohm tiamo 2.4 (process analysis) - Manual (Page 1216)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1200 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Track call on limit exceeding
In this table, which cannot be edited directly, a maximum of 20 entries
can be defined as to which track is to be started automatically when a
particular limit value is exceeded.
[New]
Opens the dialog window Track call in which the parameters for a new
track call can be entered (see Chapter 5.6.6.3.3, page 1170).
[Properties]
Opens the dialog window Track call in which the parameters for the
selected track call can be edited(see Chapter 5.6.6.3.3, page 1170) .
[Delete]
Deletes the track call selected in the table.
5.6.6.3.5.6 DOS U - Additional measured values
Tab: Methods ▶ Commands ▶ DOS U ▶ Properties... ▶ Additional measured val-
ues
Command name
Name of the command.
Entry 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together in additional measured value columns
with the measured values present in the default settings.
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be calculated from existing measured values and saved, which can also be
presented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Opens the dialog window Calc. measured value # in which the param-
eters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 933).
[Properties]
Opens the dialog window Calc. measured value # in which the param-
eters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 933).