Metrohm tiamo 2.4 (process analysis) - Manual (Page 1626)

7.18 Titrino
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1610 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
At program start
on | off (Default value: on)
If this option is switched on then at each program start the request to pre-
pare the dosing device will appear.
On attaching an exchange/dosing unit
on | off (Default value: on)
If this option is switched on then at each attaching of an exchange or dos-
ing unit the request to prepare the dosing device will appear.
Time interval
on | off (Default value: off)
If this option is switched on then the request to prepare the dosing device
will appear after the time interval defined here.
all
Time interval after which the request to prepare the dosing device will
appear.
Input range 0.1 - 999.9 h
Default value 12 h
7.18.4 Properties - Ext. Dosing device D#
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device type' -
'Device name' ▶ Ext. Dosing device D#
Request for dosing device preparation
Selection when the request for carrying out the PREP (prepare) command
(see Chapter 5.6.6.5.1, page 1207) is to be shown for the external dosing
device D1 or D2.
At program start
on | off (Default value: on)
If this option is switched on then at each program start the request to pre-
pare the dosing device will appear.
On attaching an exchange/dosing unit
on | off (Default value: on)
If this option is switched on then at each attaching of an exchange or dos-
ing unit the request to prepare the dosing device will appear.