Metrohm tiamo 2.4 (process analysis) - Manual (Page 1081)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1065
Input range 0 - 999,999 s
Default value 600 s
Measuring interval
Time interval for entering a measuring point in the measuring point list.
Input range 0.25 - 999,999.0 s
Default value 2.0 s
Stop measured value
Stop when the entered measured value has been reached since the start
of the measurement.
Input range 0 - 4,000 mAU
Selection off
Default value off
Temperature (089 Photometer)
Temperature
Measuring temperature, which can be entered manually. If the Tempera-
ture measurement is set to continuous on the General/Hardware
tab under Sensor, then the temperature will be measured continuously.
Input range 20.0 - 60 °C
Default value 25.0 °C
5.6.4.15.4 MEAS Opt Conc - Additional measured values
Tab: Method ▶ MEAS Opt Conc ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Entry 25 characters
A maximum of 6 additional measured values can be defined on this tab.
These values can then be saved together in additional measured value col-
umns with the measured values present in the default settings.
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be calculated from existing measured values and saved, which can also be
presented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.