Metrohm tiamo 2.4 (process analysis) - Manual (Page 1319)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1303
5.6.11.4 ANALOG OUT
5.6.11.4.1 ANALOG OUT - Overview
Dialog window: Method ▶ ANALOG OUT ▶ Properties... ▶ ANALOG OUT - 'Com-
mand name'
Devices
This command can be executed with the IO Controller.
Appearance
The command has the following appearance:
Mode of operation
The values which are written to the analog outputs can be either calcula-
tion results or fix values.
The values, the set values and unit of all of the analog outputs used in the
command are saved to command variables.
Parameters
The parameters for the command ANALOG OUT are configured on the
following 2 tabs:
￭ General
￭ Analog outputs
Command variables
The following command variables are generated in the method run by the
command ANALOG OUT and can be used in formulas under the desig-
nation 'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.DEF Set value which is defined in the configuration for an IO
port.
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended