Single-axis controllers – Lenze 9400 Manual User Manual
Page 104
Advertising
Single-axis controllers
Wiring
Earthing of internal EMC filters
4
104
EDS94SPP101 EN 7.1
Device size 1 ... 3
Proceed as follows to disconnect the internal connection between the filters and PE:
1. Remove IT insulating cap from the parking position c in the installation backplane.
– For this apply a screwdriver on the right or left and lever off the insulating cap.
– Optionally the insulating cap can be carefully removed using an appropriate pliers.
2. Attach IT insulating cap to the earthing jumper d until it clicks into place.
1
2
SSP94IT001
Fig. 4-19
Plugging the IT insulating cap onto the earthing jumper
Advertising