Lenze 9400 Manual - Manual (Page 354)

Accessories (overview)
Communication modules
Ethernet interface
9

354 EDS94SPP101 EN 7.1
Displays
LED
Description Pos. Colour Condition
MS Green Blinking Communication module is supplied with voltage, but has no connection to the standard device
(standard device is either switched off, in the initialisation phase, or not available).
On Communication module is supplied with voltage and has a connection to the standard device.
ME Red On There is an error in the area of the communication module.
BS Green The LED functions are controlled by the NMT state machine.
Off
EPL network is not active
(LED off)
EPL status:
NMT_GS_OFF, NMT_GS_INITIALISATION,
NMT_CS_NOT_ACTIVE / NMT_MS_NOT_ACTIVE
EPL network in the initialisation phase.
(LED flashes once within a second)
EPL status:
NMT_CS_PREOPERATIONAL_1 / NMT_MS_PREOPERATIONAL_1
EPL in the initialisation phase with cyclic traffic.
(LED flashes twice within a second)
EPL status:
NMT_CS_PREOPERATIONAL_2 / NMT_MS_PREOPERATIONAL_2
EPL node waits for the starting signal.
(LED flashes three times within a second)
EPL status:
NMT_CS_READY_TO_OPERATE / NMT_MS_READY_TO_OPERATE
EPL node has not found any EPL master and is in the ”BASIC-Ethernet” operating mode.
(LED is blinking at a frequency of 10 Hz)
EPL status:
NMT_CS_BASIC_ETHERNET
EPL node in the ”Stopped” status. Waiting for disconnection.
(LED is blinking at a frequency of 2.5 Hz)
EPL status:
NMT_CS_STOPPED
EPL node in the operating phase
(LED is on continuously)
EPL status:
NMT_CS_OPERATIONAL / NMT_MS_OPERATIONAL
BE Red Off There is no error.
On There is an error.
DE Red On The communication module is not accepted by the standard device (see notes given in the
documentation on the standard device).
Signalling at the terminals X211 or X212:
-
Red On Ethernet collision is available.
- Green On Ethernet connection is available.
Blinking Ethernet connection with active data communication