Lenze 9400 Manual - Manual (Page 461)

Accessories (overview)
Motor holding brake control modules
Motor holding brake control module E94AZHY0026
9

461 EDS94SPP101 EN 7.1
Elements of the motor brake control
Pos. Description
 Nameplate
 Connection of standard device
X107 Connection of supply and brake
Standards
Conformity and approval
Conformity
CE 2006/95/EC Low-Voltage Directive
Approval
UR UL 508C Industrial Control Equipment Recognised
(file no. E132659) for USA
Protection of persons and equipment
Enclosure
EN 60529 IP00
Protective measures Against short circuit
EMC
Noise emission
EN 61800-3 Conducted, category C2.
Noise immunity EN 61800-3 Burst on mains cable: 2 kV/5 kHz
Burst on control cable: 2 kV/5 kHz
Surge on mains cable: 1 kV (1.2 μs/50 μs;
phase - phase)
2 kV (1.2 μs/50 μs; phase - PE)
Operating conditions
The operating conditions correspond to the operating conditions for the standard device
to which the DC-feeding point is connected.
Environmental conditions
Climate
Storage IEC/EN 60721-3-1 1K3 (-25 ... +60 °C)
Transport IEC/EN 60721-3-2 2K3 (-25 ... +70 °C)
Operation IEC/EN 60721-3-3 3K3 (-10 ... +55 °C)
Site altitude 0 ... 4000 m amsl
1000 ... 4000 m amsl: current derating of 5 %/1000 m
Pollution EN 61800-5-1 Pollution degree 2
Vibration resistance (9.81 m/s 2 = 1 g)
Transport IEC/EN 60721-3-2 2M2
EN 61800-2 2 ... 9 Hz: amplitude 3.5 mm
10 ... 200 Hz: acceleration resistant up to 10 m/s
2
200 ... 500 Hz: acceleration resistant up to 15 m/s 2
Operation Germanischer Lloyd 5 ... 13.2 Hz: amplitude ±1 mm
13.2 ... 100 Hz: acceleration resistant up to 0.7 g
EN 600068-2-6 10 ... 57 Hz: amplitude 0.075 mm
57 ... 150 Hz: acceleration resistant up to 10 m/s
2