Lenze 9400 Manual - Manual (Page 412)

Accessories (overview)
Safety modules
SM301
9

412 EDS94SPP101 EN 7.1
Displays
Pos. Colour State Description
MS
(Module State)
Green
On Drive-based safety has initialised without a fault.
Blinking
Drive-based safety has initialised without a fault. Internal
communication to the standard device is not possible.
Flashing
Drive-based safety is in service status.
For exiting, parameterise the drive-based safety.
Off
Drive-based safety is not initialised.
Acknowledgement is not possible.
EN
(Enable)
Yellow
On Controller enabled
Off Non-safe display ”STO”
ME
(Module Error)
Red
On System error
Blinking Trouble
Flashing Warning
Off Error-free operation
AS
(Acknowledge Stop)
Yellow
On
Request of an acknowledgement for the restart or the
parameter set adoption
Blinking SS1/STO active
Flashing SS2/SOS active
Off No stop function active
BE
(Bus Error)
Red
On
Safety bus error:
z
Communication is not possible.
z Acknowledgement is possible.
Blinking Safety bus error: no valid configuration.
Off Safety bus: error-free operation.
DE
(Drive Error)
Red
On
Drive-based safety is not accepted by the standard device
(see notes in the instructions for the standard device).
Off
Drive-based safety is correctly recognised by the standard
device.
Blinking: on/off every 0.5 s Flashing: on/off every 0.1/0.9 s
Application range
This module may be used in conjunction with standard devices of the 9400 product series
as of nameplate inscription
Type HW SW
E94ASxExxxx VA 01.49
E94AMxExxxx VA 01.49
This module may be used together with the PROFIBUS communication module with the
nameplate designation as of
Type HW SW
E94AYCPM VB 01.xx