Lenze 9400 Manual - Manual (Page 310)

DC-bus operation
Introduction
Terminology and abbreviations used
8

310 EDS94SPP101 EN 7.1
8.1 Introduction
8.1.1 Terminology and abbreviations used
ƒ
DC bus
The energy store in the controller or supply module from which the controller
modulates the AC voltage for the motor. The DC buses of several controllers can be
networked.
ƒ DC bus
Electrical connection of the DC connections of several controllers via cable or busbar.
ƒ DC-voltage level
DC-voltage level in the DC bus
ƒ
Power supply module
Module with AC mains connection used to supply the DC bus of a drive system with DC
voltage.
ƒ
Regenerative power supply module
Power supply module with additional power regeneration into the AC mains
ƒ Multi-axis controllers (Multi Drive)
Controllers for connection to a DC bus. Multi-axis controllers have no AC mains
connection and no brake chopper.
ƒ
Single-axis controllers (Single Drive)
Controllers for connection to an AC mains or a DC bus. Single-axis controllers have an
integrated brake chopper.
ƒ
Brake chopper
Switching element in the controller used to dissipate excess energy in the DC bus via
a brake resistor.
ƒ Brake resistor
High-performance resistor used to convert excess energy in the DC-bus into heat.
ƒ
Braking operation
Motor operation in generator mode with energy feedback from the motor to the
controller.