Multi-axis controllers – Lenze 9400 Manual User Manual
Page 179
Multi-axis controllers
Mechanical installation
Important notes
5
179
EDS94SPP101 EN 7.1
Mounting grid
We recommend to provide the mounting plate with a grid pattern of M5 threaded holes
for attaching the devices. This preparation enables easy attachment of the devices, and the
device sizes 1, 2, ... n can thus be mounted directly adjacent to each other.
Note!
ƒ
M5 screw and washer assemblies or hexagon socket screws with washers
are permitted.
ƒ
Tightening torque: 3.4 Nm / 30 lb-in.
ƒ
In the installation backplane, the screwed connection may not jut out more
than 7 mm.
SSP94PN010
Mounting with backplane for attaching the power supply module
Grid hole pattern for installation backplane
Grid hole pattern for other device sizes or built-on/footprint filters (only Single Drive)
Cable duct
1
...
3
Device size, mounting holes used