Lenze 9400 Manual - Manual (Page 451)

Accessories (overview)
Motor holding brake control modules
Motor holding brake control module E94AZHY0025
9

451 EDS94SPP101 EN 7.1
Installation steps
1. Plug the motor brake control module onto the terminals  of the standard device.
– Ensure that both clips  snap into the slots  of the standard device!
2. Check that the motor brake control module is securely connected.
Terminal data
Terminal X107 Labelling Description
Connection of the motor holding brake:
BD1
BD2
+ (Lenze: WH)
- (Lenze: BN)
E94AZHY0025: 205 V DC, max. 0.75 A
Ensure correct polarity!
SSP94A6107
L1
L2/N
Supply voltage of the motor holding brake
Terminal data
Conductor cross-section Tightening torque
[mm 2 ] [AWG] [Nm] [lb-in]
Flexible
0.5 ... 2.5 20 ... 12 Spring terminal With wire end
ferrule
Stripping length or contact length: 8 mm
Connection plan
L1
L2
L3
N
PE
F10
BD1 BD1
L1 L3 PE L2 L1 L3 PE L2
BD2 BD2
M
3~
M
3~
£ 2.5 mm²
E94APNExxx4 E94ASxExxx4 E94AMxExxx4
E94AZHY0025 E94AZHY0025
L1 L2/N L2/N L1
" "
" "
X107 X107
E94AZH016
F10
Observe the cable protection standards for fuse dimensioning!
 HF shield termination through large-surface PE connection