GE Industrial Solutions DV-300 DC Drive Users Manual - Manual (Page 29)

DV-300 Adjustable Speed Drives
——— DESCRIPTION, COMPONENT IDENTIFICATION AND SPECIFICATIONS ———
2
9
As for 6KDV3...Q2C / Q4G converters see Appendix A (GEI-100332C).
During start-up the threshold for the undervoltage message has to be set via the Undervolt thr parameter
(standard: 230 V).
n
ote
! According the input voltage the switch S15.7/8 on the regulation board must be set as follows:
6KDV3...Q2A; 6KDV3...Q4E S15.7 = OFF S15.8 = OFF
6KDV3...Q2B; 6KDV3...Q4F S15.7 = ON S15.8 = OFF
6KDV3...Q2C; 6KDV3...Q4G S15.7 = OFF S15.8 = ON
n
ote
! As for the operation of the DV-300 converters AC input reactors and interference suppression
filters are required. See section 4.10, “Reactors/Filters”.
The converters above 560 / 770 A (American / European) and the AC input reactors have a
discharge currents to ground higher than 3.5 mA. EN 50178 states that beside the ground
conductor another ground connection should be laid.
C
aution
! Due to the increased discharge current involved, a fixed ground connection (without connec-
tors) for the filters of the DV-300 converter is required.
Table 2.4.2.2: AC input curents
American Current on the European Current on the Current on the Power Supply Regulation
AC Input AC Input field AC Input Power Card
6KDV3017... 17.2 A 6KDV3020... 17.2 A 10 A
70W SW1-31
6KDV3035... 34.4 A 6KDV3040... 34.4 A 10 A
6KDV3056... 60.2 A 6KDV3070... 60.2 A 10 A
6KDV3188... 75.6 A 6KDV3110... 94.6 A 14 A
6KDV3112... 96.2 A 6KDV3140... 120.4 A 14 A
6KDV3148... 127.2 A 6KDV3185... 159.1 A 20 A
110W SW2-32
6KDV3224... 192.5 A 6KDV3280... 240.8 A 20 A
6KDV3280... 240.6 A 6KDV3350... 301 A 20 A
6KDV3336... 288.7 A 6KDV3420... 361.2 A 20 A
6KDV3400... 343.7 A 6KDV3500... 430 A 20 A
6KDV3450... 386.7 A 6KDV3650... 559 A 20 A
6KDV3560... 481.2 A 6KDV3770... 662.2 A 25 A
110W SW3-32 6KDV3800... 687.4 A 6KDV310H... 860 A 25 A
6KDV3850... 730.4 A 25 A
GD0040g
* Current reduction for higher temperatures, see “Permissible ambient conditions”.
** The overload size and duration depend on the overload cycle, see section 6.14.5, “Overload control”.
As for sizes above 850 / 1050 A (American / European) see Appendix A (GEI-100332C).