GE Industrial Solutions DV-300 DC Drive Users Manual - Manual (Page 61)

DV-300 Adjustable Speed Drives
——— WIRING PROCEDURES ———
4
17
4.7.2 Terminal Assignment
Table 4.7.2.1: Terminal assignment (Terminals 0Venc and +Venc)
Designation Function I/O max volt. max curr.
0Venc 0 V supply to the encoder I - -
+Venc
+15 ... 24 V supply to the encoder (S1, S2, S3 open)
+5V supply to the encoder (S1, S2, S3 closed)
I +24V depending on encoder data
GD0260g
I = Input O = Output
Table 4.7.2.2: Permissible cable cross section on the terminals of option card 6KDV300DES
Terminals
Max cable connection section Tightening
torque
[Nm]
[mm 2 ]
AWG
flexible multi-core
0 Venc and +Venc 0.14 ... 1.5 0.14 ... 1.5 28 ... 14 0.5
GD0270
The use of a 3 x 0.1 x 0.02 inches (75 x 2.5 x 0.4 mm) flat screwdriver is recommended. Strip the ends of the
cables to a length of 0.26 inch (6.5 mm). Only one unprepared wire (without ferrite) should be connected to
each terminal.
Table 4.7.2.3: XS1 9-pole connector
Designation Function I/O max volt. max curr.
PIN 1 Channel B- I +24V 10.9mA
PIN 2 Supply voltage for the encoder (the allowed level
depends on the jumper position, see chapter 4.7.1 +24V depending on ext. power
supply unit
PIN 3 Channel C+ (zero pulse) I/O +24V 10.9mA
PIN 4 Channel C- (zero pulse) +24V 10.9mA
PIN 5 Channel A+ I/O +24V 10.9mA
PIN 6 Channel A- +24V 10.9mA
PIN 7 Reference point for supply voltage I/O - -
PIN 8 Channel B+ +24V 10.9mA
PIN 9 not connected I/O - -
GD0280g
I = Input O = Output