GE Industrial Solutions DV-300 DC Drive Users Manual - Manual (Page 313)

DV-300 Adjustable Speed Drives
——— FUNCTION DESCRIPTION ———
6
185
6.17.2.2 Taper function
OPTIONS
Torque winder
Torque calculat
Taper function
[1176] Taper enable
[1177] Init diameter [m]
[1178] Final diameter [m]
[1180] Tension ref [%]
[1179] Tension red [%]
[1194] Act tension ref [%]
Parameter description No.
Value
Standard
Configuration min max
Factory
American
Factory
European
Taper enable
Enabled (1) / Disabled (0)
1176 0 1 Disabled (0) Disabled (0) *
Init diameter [m] 1177 0.000 32.000 0.1 0.1
Final diameter [m] 1178 0.000 32.000 1 1
Tension ref [%] 1180 0.00 199.99 0 0 **
Tension red [%] 1179 0.00 199.99 0 0 **
Act tension ref [%] 1194 0.00 200.00 0 0 ***
* This parameter can be set on a programmable digital input.
** This parameter can be set on a programmable analog input.
*** This parameter can be set on a programmable analog output.
Tension ref
Min
diameter
Max
diameter
Init
diameter
Final
diameter
Tension ref x 1 -
Tension red
100
Roll diameter
Act tension ref
Figure 6.17.2: Relation among the Taper function parameters
Taper enable Enabling of Taper function.
Init diameter Diameter for the starting of the taper tension reduction in meters.
Final diameter Diameter for the ending of the taper tension reduction in meters.
Tension ref Tension reference in %.
Tension red Taper tension reduction as a percentage of Tension ref.
Act tension ref Monitor for the active tension reference as a percentage of Tension ref.