GE Industrial Solutions DV-300 DC Drive Users Manual - Manual (Page 53)

DV-300 Adjustable Speed Drives
——— WIRING PROCEDURES ———
4
9
3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 1 2
23 24 25 26 27 28 29 30 31 32 33 34 37 38 39 40 41 42 21 22
Figure 4.4.2: Disposition of terminals from 1 to 42
Table 4.4.6 - A: Terminal Assignment (terminals from 1 to 20)
Terminal
Designation
Function I/O Max
voltage
Max
current
1 +2 Configurable analog differntial input
I ±10V
0.25mA
Analog input 1 Signal: Term. 1, Reference point Term. 2 (20mA at current
Factory set for Ramp ref 1* ref. value)
3 +4 Configurable analog differntial input
I ±10V
0.25mA
Analog input 2 Signal: Term. 3, Reference point Term. 4 (20mA at current
Not factory set ref. value)
5 +6 Configurable analog differntial input
I ±10V
0.25mA
Analog input 3 Signal: Term. 5, Reference point Term. 6 (20mA at current
Not factory set ref. value)
7 Reference voltage +10V
O +10V 10mA
+10V Reference point: Term. 9
8 Reference voltage -10V
O -10V 10mA
-10V Reference point: Term. 9
9 Reference point for the reference voltages on
— — —
0V 10 terminal 7 and 8
10 Screen connection (PE) (connected with housing) — — —
11 internal 0V — — —
12 Converter enable
I +30V
15V/3.2mA
Enable drive 0V Disabled converter 24V/5mA
+15...30V Enabled converter 30V/6.4mA
13 Start command
I +30V
15V/3.2mA
Start 0V No start command 24V/5mA
+15...30V Start 30V/6.4mA
14 Fast stop
I +30V
15V/3.2mA
Fast stop 0V Fast stop 24V/5mA
+15...30V No Fast stop 30V/6.4mA
15 External fault
I +30V
15V/3.2mA
External fault 0V External fault present 24V/5mA
+15...30V No external fault present 30V/6.4mA
16 Reference point of the digital inputs,
— — —
COM ID terminals 12 to 15
18 Reference point of the 24V voltage
— — —
0V 24 on terminal 19
19 Voltage +24V
O +20...30V 200 mA**
+24 V Reference point Terminal 18
20 Screen connection (PE) (connected w/housing) — — —
GD0180g
* The user can adapt the configuration to the requirements of the application concerned via the keypad, the serial interface or a
bus connection.
** Total value including Terminal 19, Pin 2 of connector XE2 and the digital outputs on the option card 6KCV300TBO.