GE Industrial Solutions DV-300 DC Drive Users Manual - Manual (Page 42)

GEI-100332Ga
——— INSTALLATION GUIDELINES ———
3
2
3.2 DISpOSAL OF ThE DEVICE
The converters of the DV-300 series can be disposed as electronic scraps in accordance with the currently valid
national regulations for the disposal of electronic parts.
The plastic covering of the converters up to type 185 A are recyclable: the material used is >ABS+PC< “-FR”
3.3 INSTALLATION, MOuNTING CLEARANCE
Mounting the device
n
ote
! The dimensions and weights specifed in this manual should be taken into consideration when
the device is mounted. The technical equipment required (carriage or crane for large weights)
should be used. Improper handling and the use of unsuitable tools may cause damage.
max. 30
°
Figure 3.3.1: max Angle of Inclination
The maximum angle of inclination is 30°.
The converters must be mounted in such a way that the free flow of air is ensured.
The clearance to the device must be at least 6 inches (150 mm).
A space of at least 2 inches (50 mm) must be ensured at the front.
Devices that generate a large amount of heat must not be mounted in the direct vicinity of the frequency inverter.
n
ote
! Mounting screws should be re-tightened after a few days of operation.