Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1004)

994 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
14
ip-mac conflict drop-only
ip-mac conflict [log-and-drop|log-only] log-level
[<0-7>|alerts|critical|debug|
emergencies|errors|informational|notifications|warnings]
ip-mac routing conflict drop-only
ip-mac routing [log-and-drop|log-only] log-level [<0-7>|alerts|critical|debug|
emergencies|errors|informational|notifications|warnings]
conflict Action performed when a conflict exists between the IP address and MAC address. This option is enabled
by default.
drop-only Drops a packet without logging
conflict Action performed when a conflict exists between the IP address and MAC address. This option is enabled
by default.
log-and-drop Logs the event and drops the packet. This is the default setting.
log-only Logs the event only, the packet is not dropped
log-level Configures the log level
<0-7> Sets the numeric logging level
alerts Numerical severity 1. Indicates a condition where immediate action is required
critical Numerical severity 2. Indicates a critical condition
debugging Numerical severity 7. Debugging messages
emergencies Numerical severity 0. System is unusable
errors Numerical severity 3. Indicates an error condition
informational Numerical severity 6. Indicates a informational condition
notification Numerical severity 5. Indicates a normal but significant condition
warnings Numerical severity 4. Indicates a warning condition. This is the default setting
routing Enables IPMAC routing conflict detection. This is also known as a Hole-196 attack in the network. This
feature helps to detect if the client is sending routed packets to the correct router-mac-address.
conflict Defines the action performed when a routing table conflict is detected. This option is enabled by default.
drop-only Drops a packet without logging
routing Defines a routing table based action
conflict Action performed when a conflict exists in the routing table. This option is enabled by default.
log-and-drop Logs the event and drops the packet. This is the default setting.
log-only Logs the event only, the packet is not dropped
log-level Configures the log level to log this event under
<0-7> Sets the numeric logging level
alerts Numerical severity 1. Indicates a condition where immediate action is required
critical Numerical severity 2. Indicates a critical condition
debugging Numerical severity 7. Debugging messages
emergencies Numerical severity 0. System is unusable
errors Numerical severity 3. Indicates an error condition