Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 743
730
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
An association ACL is a policy-based Access Control List (ACL) that either prevents or allows
wireless clients from connecting to a controller managed access point radio. An ACL is a sequential
collection of permit and deny conditions that apply to controller packets. When a packet is received
on an interface, the controller compares the fields in the packet against any applied ACLs to verify
the packet has the required permissions to be forwarded, based on the criteria specified in the
access lists. If a packet does not meet any of the criteria specified in the ACL, the packet is
dropped.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
use [association-acl-policy|radio-qos-policy]
use [association-acl-policy <ASSOC-ACL-POLICY-NAME>|radio-qos-policy
<RADIO-QOS-
POLICY-NAME>]
Parameters
use [association-acl-policy <ASSOC-ACL-POLICY-NAME>|radio-qos-policy
<RADIO-QOS-POLICY-NAME>]
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#use
association-acl-policy test
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
rf-mode sensor
placement outdoor
mesh client
rts-threshold 100
off-channel-scan channel-list 2.4GHz 1
guard-interval long
aggregation ampdu tx-only
rifs tx-only
use association-acl-policy test
sniffer-redirect omnipeek 172.16.10.1 channel 1
aeroscout forward
ekahau forward ip 172.16.10.1 port 3
non-unicast tx-rate bss 1 dynamic-all
non-unicast tx-rate bss 2 highest-basic
non-unicast tx-rate bss 3 highest-basic
--More--
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
association-acl-policy
Uses a specified association ACL policy with this radio interface
•
<ASSOC-ACL-POLICY-NAME> – Specify the association ACL policy name (should be existing and fully
configured).
radio-qos-policy
Uses a specified radio QoS policy with this radio interface
•
<RADIO-QoS-POLICY-NAME> – Specify the radio QoS policy name (should be existing and fully
configured).