Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 334)

318 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
802.11w) related configuration (DEMO
FEATURE)
proxy-arp-mode Configure handling of ARP requests
with proxy-arp is enabled
radio-resource-measurement Configure support for 802.11k Radio
Resource Measurement
radius Configure RADIUS related parameters
relay-agent Configure dhcp relay agent info
shutdown Shutdown this wlan
ssid Configure the Service Set Identifier
for this WLAN
time-based-access Configure client access based on time
use Set setting to use
vlan Configure the vlan where traffic from
this wlan is mapped
vlan-pool-member Add a member vlan to the pool of
vlans for the wlan (Note:
configuration of a vlan-pool
overrides the 'vlan' configuration)
wep128 Configure WEP128 parameters
wep64 Configure WEP64 parameters
wireless-client Configure wireless-client specific
parameters
wpa-wpa2 Modify tkip-ccmp (wpa/wpa2) related
parameters
clrscr Clears the display screen
commit Commit all changes made in this
session
do Run commands from Exec mode
end End current mode and change to EXEC
mode
exit End current mode and down to previous
mode
help Description of the interactive help
system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory
or terminal
rfs7000-37FABE(config-wlan-1)#
wlan-mode commands
wlan
This section documents the WLAN configuration mode commands in detail.
Use the (config) instance to configure WLAN related parameters.
To navigate to this instance, use the following command:
<DEVICE>(config)#wlan <WLAN-NAME>