Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 755)

742 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
use Set setting to use
username Enter username provided by the service provider
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
nx4500-5CFA2B(config-profile-default-nx45xx-if-serial-1/1:1)#
shutdown
interface-config-serial-instance
Shuts down the serial interface. Use the no shutdown command to re-start a serial interface.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
shutdown
Parameters
None
Example
nx4500-5CFA2B(config-profile-default-nx6500-if-serial-1/1:1)#shutdown
Related Commands:
interface-config-t1e1-instance
interface
The T1/E1 interfaces are physical layer interfaces that support data, voice, or a combination of
data and voice applications.
Use the (config-profile-<DEVICE-PROFILE-NAME>) instance to configure the T1E1 interface
associated with the service platform.
To switch to this mode, use the following command:
<DEVICE>(config)#profile <DEVICE-TYPE> <DEVICE-PROFILE-NAME>
no Disables or reverts serial interface settings to their default