Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 764)

Brocade Mobility RFS Controller CLI Reference Guide 751
53-1003098-01
7
• Service Platforms — Brocade Mobility RFS9510
Syntax:
address [<IP>|range]
address range <START-IP> <END-IP>
Parameters
address [<IP>|range <START-IP> <END-IP>]
Example
rfs7000-37FABE(config-profile-default-rfs7000-nat-pool-pool1)#address range
172.
16.10.2 172.16.10.8
rfs7000-37FABE(config-profile-default-rfs7000-nat-pool-pool1)#show context
ip nat pool pool1
address range 172.16.10.2 172.16.10.8
rfs7000-37FABE(config-profile-default-rfs7000-nat-pool-pool1)#
Related Commands:
no
nat-pool-config-instance
Removes address(es) configured with this NAT pool
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no address
Parameters
None
Usage Guidelines:
The no command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
address <IP> Adds a single IP address to the NAT pool
range <START-IP>
<END-IP> Adds a range of IP addresses to the NAT pool
•
<START-IP> – Specify the starting IP address of the range.
•
<END-IP> – Specify the ending IP address of the range.
no Removes address(es) configured with this NAT pool